Wavelength Manipulation Attack in Free-Space
The Wavelength Manipulation Attack in free-space Quantum Key Distribution systems involves using an external laser to alter the wavelength of the laser diodes used in state preparation. By precisely controlling the wavelength of emitted photons, the threat actor (Eve) can distinguish and decode the quantum states, gaining unauthorized access to the cryptographic key without detection.
The transmitter (Alice) encodes with one laser diode per polarisation state, each behind its own polariser, so a polarised beam that Eve sends back into Alice's output aperture heats the diodes by different amounts and separates their emission wavelengths. The polarisation Alice chose is then readable as a colour, without the polarisation itself being measured, which is why nothing in the link's error rate moves.
Eve then has two ways to finish, and they differ in what she needs. In the route demonstrated first, she reads each photon's wavelength with her own filters and detectors and sends the receiver (Bob) a matching state from her own copies of Alice's diodes, standing in for Alice on the link so that Bob cannot tell she is there. In the later route she needs no detectors at all: she tunes her beam to Alice's own operating wavelength so that it passes Alice's output filter, and that filter then blocks the diodes she has heated, leaving only the one state she chose to reach Bob. Either way she takes the publicly exchanged basis information and reconstructs the whole key [Lee2017,Lee2019].
| [Fei2018] | Y. Fei, X. Meng, M. Gao, Y. Yang, H. Wang, and Z. Ma. "Strong light illumination on gainswitched semiconductor lasers helps the eavesdropper in practical quantum key distribution systems" In: Optics Communications 419, 83. (2018) 10.1016/j.optcom.2018.03.029. |
| [Lee2017] | M. Lee, M. Woo, J. Jung, Y. Kim, S. Han, and S. Moon. "Free-space QKD system hacking by wavelength control using an external laser" In: Opt. Express 25, 11124. (2017) 10.1364/OE.25.011124. |
| [Lee2019] | M. Lee, M. Woo, Y. Kim, Y. Cho, S. Han, and S. Moon. "Quantum hacking on a free-space quantum key distribution system without measuring quantum signals" In: J. Opt. Soc. Am. B 36, B77. (2019) 10.1364/JOSAB.36.000B77. |
| [Rau2015] | M. Rau, T. Vogl, G. Corrielli, G. Vest, L. Fuchs, S. Nauerth, and H. Weinfurter. "Spatial Mode Side Channels in Free-Space QKD Implementations" In: IEEE Journal of Selected Topics in Quantum Electronics 21, 187–191. (2015) 10.1109/JSTQE.2014.2372008. |
64e1cc8a-9868-4860-97ec-77610c2b789c
- Quantum Communication
Technique properties
Operational properties
| Description | Countermeasure |
|---|---|
|
Encoding with a single laser diode removes the attack surface rather than defending it, because a one-source transmitter has no inter-diode difference to induce. [Lee2017] records that modulating the polarisation from one diode is the alternative to the four-diode design and that it has the security advantage, the four-diode route being preferred for speed, and [Fei2018] states independently that wavelength variation does not affect single-laser systems such as phase-encoding ones. |
CM-0056 Single Laser Diode Utilization |
|
State-preparation monitoring checks that each emitted signal is correctly timed, appropriately polarised and at the expected wavelength, and emission wavelength is exactly the quantity this technique perturbs. Monitoring it at the transmitter catches both routes at the point of the leak: the induced shifts are large relative to a spectrometer's resolution [Lee2017]. The draft ISO/IEC 23837-2 clause 7.6 is the corresponding test, measuring whether states encoded in one degree of freedom are distinguishable in the non-encoding ones, naming wavelength among them. |
CM-0016 State Preparation Monitoring |
|
A watchdog detector at the transmitter's optical input monitors incoming light and alarms on power that cannot be legitimate traffic, which is the first control every source names for this attack. [Lee2017] calls for an external strong laser monitoring unit to detect Eve's attempt, [Lee2019] asks for a device to measure incoming light, and [Fei2018] for real-time monitoring of the incoming light's intensity. The margin is large: the heating beams are bright against a channel carrying single photons [Lee2017]. |
CM-0011 Watchdog Detector |
|
Monitoring the laser diodes' own temperature is the control that sits closest to the mechanism, and it is the one [Fei2018] recommends outright: legitimate users should monitor diode temperature in real time and the system should alarm and abort the key once a threshold is exceeded. The observable is directly calibrated, since [Lee2017] measured how the emission wavelength follows the diode temperature, so a temperature reading maps onto an emission shift. It also has normative backing: ETSI GS QKD 008 clause 4.7.4.1 already requires a QKD module to monitor operating temperature and respond to fluctuations that are accidental or induced. |
CM-0040 Temperature Monitoring |
|
A narrow band-pass or interference filter at the transmitter's optical port rejects out-of-band light, which stops the 2017 variant of this attack, where the heating beam is out of band. [Lee2017] offers it on exactly those terms, as helpful against Eve's strong laser with different wavelengths. It must be understood as sitting at the transmitter's port against an inbound beam: a receiver-side filter is irrelevant here, because the wavelength-shifted photons never reach the receiver at all. The control is defeated by the in-band variant. |
CM-0013 Employment of Optical Filters |
|
Randomising the transmitter's emission wavelength under its own control destroys the usefulness of the label this attack creates. [Lee2017] proposes it as one of its three protection methods, and CM-0057 exists because of that proposal, citing this paper as its source: deliberate variation obfuscates the shifts an external attacker induces, so a measured wavelength no longer identifies which diode fired. |
CM-0057 Wavelength Randomization |
|
An optical isolator at the transmitter's output attenuates light travelling back into the device, which is the path Eve's heating beam must take, so it limits the power that reaches the diodes. All three sources recommend it: [Lee2017] notes that passive devices such as isolators would be helpful, [Lee2019] asks for an isolator in Alice to limit Eve's injected power, and [Fei2018] lists installing an isolator among the measures that help detect or prevent strong light illumination. |
CM-0008 Employment of Optical Isolation |
| Description | Category | Impact Type |
|---|---|---|
|
Physical layer, quantum and optical, and the primary target. The attack is delivered as light into the transmitter's optical aperture and acts on the emission wavelength of a semiconductor diode, mediated by the passive polarising optics in front of it; in the second route the selecting element is the transmitter's own interference filter [Lee2017,Lee2019]. Everything the attack touches at the victim is bulk optics and diode physics. |
L1 — Physical Layer (Quantum & Optical) | Primary Target |
|
Electronics and analog components, as a secondary effect rather than the target. The thermoelectric cooler and its control loop are what should hold the emission wavelength constant, and the attack defeats them by capacity rather than by any logic error: the junction temperature rises as long as the illumination is strong enough [Fei2018]. |
L2 — Electronics & Analog Components | Secondary Effect |
| Relation type | Description | Technique |
|---|---|---|
| Alternative to |
A-0066 Injection-Locking Attack reaches the same readout as this technique by different physics, and the pair is worth navigating between because the resemblance is easy to miss. In both, the threat actor sends polarised light backwards into the transmitter, the transmitter's own polarisation optics admit it in different amounts depending on which state is selected, and the resulting shift in the transmitter's emission frequency reveals that state. A-0066 produces the shift by locking the laser's cavity to an external reference; this technique produces it by heating the diode, which is why it works with light far outside the lasing line. The same observable, a state-dependent frequency shift in the transmitter's own emission, therefore has two distinct causes. |
A-0066 Injection-Locking Attack (ILA) |
| Alternative to |
A-0081 Spatial Misalignment Exploitation and this technique are two routes to the same outcome against the same architecture, separated by degree of freedom and by whether the difference is found or made. Both attack a free-space transmitter that encodes with several laser diodes, both end in full knowledge of the key, and both carry cat03. A-0081 reads a spatial difference that is already there, caused by angular misalignment of the diodes; this technique induces a spectral difference that was not. [Rau2015] analyses both degrees of freedom in one fielded sender and keeps their countermeasures separate, single-mode filtering for the spatial route and matched-spectra selection with an output filter for the spectral one, which is why the two rows share CM-0056 but not much else. |
A-0081 Spatial Misalignment Exploitation in QKD |
|